Need help with Configuring a Power Chrom Symphony 48

[EZ-Slider]

Hey all,
Getting ready to order a Symphony 48 with Power Chrom 1/2 valved.
Just wondering if someone can check my layout?
thanks
O and yes it is also Orchestra tuning also.. Starting on G below C
Thanks for the help.
EZ

[llumagsara]

Hey all,
Getting ready to order a Symphony 48 with Power Chrom 1/2 valved.
Just wondering if someone can check my layout?
thanks
O and yes it is also Orchestra tuning also.. Starting on G below C
Thanks for the help.
EZ

EZ, last note better a G than a G#...

that's the 1st one i think as an alternate tuning, with half valve system, you can (two reeds) bend 8 notes per octave and (one reed) bend the other 4, so very expressive, and very similar to solo tuning, you can begin practice it in a solo chrome, doing C scale with blow F...

good health

Agustín

[EZ-Slider]

Good catch on the G. That's what I was going for. Does my valve layout look right? Make sense to half valve the slide?

[Gnarly He Man]

Looks good-
I don't prefer half valving, but it works very well with this tuning.
Key of G, Power Chromatic--right on!

[EZ-Slider]

Thanks Gary..
Might still have you do my SCX 56 at some point.. I had talked with you a year or so back about it.. Sry for radio silence, the other slide in my life took center stage for a bit. Bass Trombone ;-)
EZ

[llumagsara]

Good catch on the G. That's what I was going for. Does my valve layout look right? Make sense to half valve the slide?

that tuning was made for being able to bend in all holes, look that in all holes blow note it's a tone down than draw note, so you can bend a semitone in all holes, also with slide...
When i had Brendan Power playing in front of me, i didn't notice any diference between valve and unvalved notes, perhaps you'll need to embossing slots...

good health

Agustín

[Gnarly He Man]

Thanks Gary..
Might still have you do my SCX 56 at some point.. I had talked with you a year or so back about it.. Sry for radio silence, the other slide in my life took center stage for a bit. Bass Trombone ;-)
EZ

NO worries, I just wait until they get here and put them in line.

[EZ-Slider]

Hey Gary, Just to be painfully clear.. I should have valves on my draws and not on blows like I do right?
Thanks.
EZ

[Gnarly He Man]

We remove the valves on the outside of the Harmonica – – I just created one yesterday!

[EZ-Slider]

Thanks Gary.. So all valves on bottom too?
Thanks again. Oh.. Shoot me a msg with a quote for a fine tune on a new harp.

[Gnarly He Man]

All the ones on the outside—leave all the ones inside.